# Green Stuff Roll Maker Megathread - just roll with it

**URL:** https://discourse.chaos-dwarfs.com/t/green-stuff-roll-maker-megathread-just-roll-with-it/2121
**Category:** Sculpting Tutorials
**Created:** [25 July 2021 14:50 UTC](https://discourse.chaos-dwarfs.com/t/green-stuff-roll-maker-megathread-just-roll-with-it/2121 "2021-07-25T14:50:27Z")
**Posts on this page:** 1
**Showing post:** 16

<div class="post-metadata">

### Author: ![Reaver](https://discourse.chaos-dwarfs.com/user_avatar/discourse.chaos-dwarfs.com/reaver/32/209_2.png) [@Reaver](https://discourse.chaos-dwarfs.com/u/Reaver)
#### Post date: [25 July 2021 23:27 UTC](https://discourse.chaos-dwarfs.com/t/green-stuff-roll-maker-megathread-just-roll-with-it/2121/16 "2021-07-25T23:27:03Z")

</div>

Challenge Accepted!

**Legion of Azgorh Beards**

1. Started with small-small plates and rolled a thin tube. Worth noting I mixed the green stuff with more green than I usually do to increase pliability and hopefully pick up more detail. Consequence of this is that it sticks to the roller easier if not using plenty of water.  

2. Leaving a few coils intact I went at it with the sculpting tool. Lightly pressing around the coil to replace the coil texture with messy hair strands. I repeated this with the pointy end of the tool going both directions (up and down the beard).  

3. Repeated for multiple sections and drew out the bottom. Also used a wet blade to scrape up the coils a tad, could also do that after a partial cure so as not to flatten the beard with a heavy hand. Not perfect but quick and reasonable? Let me know your thoughts @GhraskDragh

---

_[View the full topic](https://discourse.chaos-dwarfs.com/t/green-stuff-roll-maker-megathread-just-roll-with-it/2121)._